Water Tech 77000RR, Руководство оператора

Страница: 25 / 28

?
24
• Can I remove the robot before it has finished a full cycle?
• Yes, the robot can be removed from the pool at any time. Please remember to turn the robot OFF
when removing from the pool, or leave it facing the pool when in “sleep mode”.
• How do I remove the robot from the pool?
• The CX-1 includes a hook which can be mounted to any standard pool pole. Use the hook to pick the
robot up by the rubber handle. Refer to page 14 of the manual for more information.
• Can I unplug the charger before the robot is fully charged?
• Yes, just note that the runtime will be decreased.
• Why won’t it clean my carpet?
• Because your robot is a water filtering machine for pools.
• Can I charge the robot in the pool?
• No, absolutely not! ALWAYS remove the robot from the pool and charge in a DRY, SHADED AREA.
• Can I charge the robot immediately after taking it out of the pool?
• Yes, just make sure the pins of the unit’s charging jack are dry.
• Charge the robot in a dry, shaded location.
• Can I turn the robot ON while charging?
• No, the robot has safety features to prevent it from turning ON while charging. If the robot does turn
ON during charging, contact Water Tech Customer Service.
•
DO NOT ATTEMPT TO SUBMERGE THE ROBOT IN WATER WHILE IT IS CHARGING!
• How do I know if the robot is fully charged?
• The two lights for the batteries will flash while charging and stay ON when fully charged.
• A full charge will take roughly 6-8 hours.
• How do I know if the battery is fully discharged?
• When all lights are OFF, the robot is fully discharged.
• There are 2 lights blinking on the robot, what is wrong?
• When the 2 lights for the batteries are blinking, the battery power is low. Refer to page 6 for
familiarization with the Control Panel.
• Why is the robot climbing the walls in floor only mode?
• When in floor only mode, the CX-1 will climb the walls just enough to go parallel with the wall. This
helps the robot better reach debris along the edge of the floor and wall.
• How often should I clean the filter?
• Clean the filter after every use or more frequently as needed when you notice one of the following:
• Difficulty picking up debris.
• Difficulty flipping over when upside-down.
• Clouds or small debris coming from the exhaust.
CX-1 FAQs