Water Softener
Page 3 of 18
Important Safety Information – Read All
Instructions Before Using
Before beginning installation, read these instructions completely. Then obtain all the materials
and tools needed for installation.
NOTE:
Failure to install the WATER DOCTORS system correctly voids the warranty.
Perform installation according to state and local plumbing codes.
-
Use only lead-free solder and flux for sweat-solder connections, as required by state and
federal codes.
Handle all components of the
WATER DOCTORS
system with care. Do not drop, drag or turn
components upside down.
Be sure the floor under the water softening system is clean and level.
The
WATER DOCTORS
system uses 24 volt-60Hz electrical power. Always use the transformer
supplied.
-
Plug transformer into an indoor 120 volt, grounded outlet.
-
Properly ground
WATER DOCTORS
system to conform with all codes and ordinances.
Install
WATER DOCTORS
system in a protected area. Be sure electric outlet and transformer do
not come in contact with water. See
Where to Install the Softener
,
in the installation section of the
manual
.
-
Do not attempt to treat water over 110°F with the
WATER DOCTORS
system. Always
connect the
WATER DOCTORS
system to the main water supply pipe
before
water
heater.
-
Do not expose this
WATER DOCTORS
system to freezing temperatures. Water freezing
in the system will cause equipment damage.
-
Do not install in direct sunlight. Heat from sun may cause damage.
Minimum inlet water pressure is 20 psi. Maximum inlet water pressure is 125 psi. Use pressure
reducing valve if necessary.
Sodium used in the water softening process should be considered as part of your overall dietary
salt intake. Contact physician if you are on a low sodium diet.
Use clean water softening salts only, at least 99.5% pure. Failure to use the correct salt may
create a health hazard or maintenance problems.
- Pellet or coarse solar salt are the preferred salt choice. Rock salt is acceptable but will require
more brine tank maintenance
- Do not use granulated or ice cream making salts.
Always keep the salt lid in place unless servicing the unit or replenishing salt.
CAUTION:
Read and follow the information in this manual to
minimize the risk of electric shock or personal injury.
IMPORTANT!
If you are unsure about installing you’re WATER
DOCTORS water softener, contact the Pentair Water Treatment helpline
or consult a professional plumber.
IMPORTANT!
This system must be installed in compliance with
applicable state and local codes, law, and regulations.
!
CAUTION:
Do not use with water that is unsafe or of unknown quality.
Test water periodically to verify that the system is performing
satisfactorily.
Discard small parts remaining after the installation.
!
