INStaLLatIoN
n
Ensure power supply (transformer) is in the off position.
n
Plug the power supply lead into its own dedicated 220-240V, 50Hz AC electrical outlet.
It is essential the power point is properly connected to an earth leakage circuit breaker and
properly earthed to ground. Consult a qualified electrician if you are unsure.
IMPoRtaNt Note:
The cleaners power supply is also equipped with a Residual-Current Device (RCD).
This device disconnects the power circuit whenever it detects that there is not a balance between
the power and the return neutral conductor. Such an imbalance is sometimes caused by current
leakage through the body of a person who is grounded and accidentally touching the powered part of the circuit and will prevent injury caused
by such shocks. They are not intended to provide protection against overload or short circuit conditions, the earth leakage circuit breaker below
will handle this situation.
WaRNING:
It is strongly recommended that you test the RCD prior to using the cleaner power supply.
RcD oPeRatIoN:
1. Plug power supply lead into dedicated electrical outlet.
2. Press RESET button and the indicator light should be on “Lite”.
3. Press TEST button and the indicator light should be on “Off”.
4. Press RESET button for use of the cleaner, do not use if TEST fails and indicator is on “Lite”.
n
This RCD is not an overload protection device.
n
This RCD device complies SAA AS/NZS3190, Approval No A/10643EA.
n
Do not plug the power supply lead into an extension cord.
n
Plug in the connector of the power cord from the cleaner into the power supply. The connector is keyed so that it will
only plug into the power supply one way. Make sure that the plug is pushed all the way onto the power supply.
Slide the connector lock (strain relief) onto the connector and turn the connector lock clockwise until it is tight (Do not over tighten).
WaRNING:
1. DO NOT RUN THE CLEANER OUT OF THE WATER. OPERATING THE CLEANER OUT OF THE WATER WILL DAMAGE THE MOTORS AND VOID THE WARRANTY
2. THE ADMIRAL SHOULD NOT BE CONNECTED TO A TIMING DEVICE AND LEFT CONTINUOUSLY WITHIN A POOL OR SPA.
n
Place the Admiral into the pool and rock the cleaner side to side to
release any trapped air. The cleaner will sink to the bottom of the pool.
n
Place a sufficient length of the power cord into the water that will enable the
Admiral to easily reach all areas of the pool.
(Do not place ALL of the power cord into the pool unless required).
n
Turn on power supply at dedicated 220-240V, 50Hz AC electrical outlet and switch power
supply to the on position, and the Admiral will begin its cleaning program.
n
The Admiral will automatically shut itself down after two hours.
n
If a second cleaning is required or the Admiral is accidentally shut off, you should wait one
minute before switching the cleaner on again. The cleaner has an automatic lock out
period to protect the electronic intelligent navigation devices.
IMPoRtaNt Note:
During normal operation, the cleaner will appear to shut off for a few seconds, raise the front
wheels off the pool bottom and move either left or right or turn for an undetermined amount of
time. This is normal and has been pre-programmed into the unit to assure the quickest and most
efficient cleaning of your pool.
4
Содержание Admiral
Страница 14: ...NOTES 14 ...
Страница 15: ...NOTES 15 ...
