Bag #23834A004
23833A09
CONSUMER HOT-LINE:
1-800-942-3343
Monday–Friday 7 AM to 5 PM EST
www.waterace.com
INSTALLATION MANUAL
Pgs. 1–12
SUBMERSIBLE WELL PUMPS
POMPES SUBMERSIBLES DE PUISARD
MANUEL D’INSTALLATION
Pgs. 13–24
MANUAL DE INSTALACIÓN
Pgs. 25–36
BOMBAS SUMERGIBLES PARA SUMIDEROS
STEP 1
Carefully tie a small but heavy weight to the end of a piece
of string (be sure there is enough string; some wells are very
deep). Lower weight into well until it reaches bottom.
STEP 2
Take up slack and mark string at ground level. Pull weight out
of well and measure from bottom of weight to ground level
mark. This is the depth of your well.
STEP 3
*Subtract ten feet from this depth. This number should not
exceed the pumping depth of your pump. If it does, it will
prevent the proper operation of the pump.
STEP 4
Subtract twelve feet from the depth of your well. This is the
approximate length of polytubing or piping needed to install
pump. Now you should know the depth of your well. Please read
the entire installation manual carefully before you begin the
well pump installation.
If you require assistance with your
well pump installation, please call the Water Ace consumer
hot-line: 1-800-942-3343 or access www.waterace.com for
additional information.
WARNING! FAILURE TO FOLLOW THESE INSTRUCTIONS AND
COMPLY WITH ALL CODES MAY CAUSE SERIOUS BODILY
INJURY AND/OR PROPERTY DAMAGE.
BEFORE YOU BEGIN, YOU SHOULD KNOW THE DEPTH OF YOUR WELL. WATER ACE SUGGESTS THE
FOLLOWING FOUR EASY STEPS IN DETERMINING YOUR WELL DEPTH.
2-WIRE MODELS
R200A
PART NO. 2320D500, /2 HP, 0 GPM, 5 V
R201A
PART NO. 2324D500, /2 HP, 0 GPM
R202A
PART NO. 2328D500, 3/4 HP, 0 GPM
R203A
PART NO. 23222D500, HP, 0 GPM
R214A
PART NO. 23225D500,
/
2
HP, 6 GPM
R2254A
PART NO. 24350D503,
/
2
HP, 25 GPM
R2354A
PART NO. 24350D505,
/
2
HP, 35 GPM
3-WIRE MODELS
R300A
PART NO. 23242D500, /2 HP, 0 GPM
R301A
PART NO. 23246D500, 3/4 HP, 0 GPM
R302A
PART NO. 23250D500, HP, 0 GPM
R3065A
PART NO. 23240D500, /2 HP, 6 GPM
R3067A
PART NO. 23244D500, 3/4 HP, 6 GPM
R30610A
PART NO. 23248D500, HP, 6 GPM
R31015A
PART NO. 23254D500,
/
2
HP, 0 GPM
R314A
PART NO. 23253D500,
/
2
HP, 6 GPM
R3183A
PART NO. 2325D500, HP, 8 GPM
R3184A
PART NO. 23255D500,
/
2
HP, 8 GPM
R3207A
PART NO. 23247D500, 3/4 HP, 8 GPM
R3254A
PART NO. 24350D502,
/
2
HP, 25 GPM
R3354A
PART NO. 24350D504,
/
2
HP, 35 GPM
Typical 3-4 bedroom home requires 8-12 GPM
Note: If your well depth is over 200 feet
deep you may want to consider contacting
a professional well pump installer to assist
you.
Piping filled with water in conjunction
with the weight of the pump can become
very heavy. Please seek assistance during
the well pump installation or dismantling.
*Ten feet above the bottom well is the
maximum setting. The draw down is the
lowest water level after the pump is turned
on. Well pumps can be set ten (0) feet
below the draw down, if the draw down
is known.
Knowing Your Well Depth
(Rev. /6/05)
