4
Installation
Step 1: Installing The Camera
a.
Carefully cut & remove the plastic binding strap that is holding the backplate to the main camera body and then remove
the backplate from the rear of the camera housing. An image of the backplate is shown above.
b.
You will see on the backplate both a large 6VDC battery and a small 9V DC Battery. Connect the large red and black
battery wire leads for the 6VDC Battery to the corresponding colour terminals on the battery.
c.
Remove the 9VDC Battery by unscrewing the battery hold down strap. Remove the plastic protective wrap and then
replace the battery. Now connect the 9V Battery to the clip-on connector.
IMPORTANT: The 9 Volt Battery is only
intended for temporary use to ensure sufficient power is available for you to set-up the initial installation and
give the solar panel sufficient time to charge the large 6VDC Battery. The 9 Volt battery should be removed
within 1 month of installation, otherwise if left in place it may leak and damage the systems electronics. This is
not covered by warranty.
d.
Adjust the “Transmission Time Switch (SW3) to select the transmission time of video and audio when the PIR senses
movement. It can be set as either 10,20,30 or 40 seconds. Please consider how often movement is likely to be
detected in your installation. The shorter you set the transmission time the less power will be used from the battery, and
the less sunlight will be required to recharge. In most installations 20 seconds transmission time should be adequate.
e.
Adjust the “Channel Selection Switch (SW2) to select which channel you want your system to transmit on. (In Australia
you must only use channels 1, 2 or 3.
DO NOT USE CHANNEL 4)
. Make sure you remember which channel you have
Battery Hold Down Strap
Channel Selection Switch (SW2)
Transmission Time Switch (SW3)
Reset Switch (SW1)
Optional Input For 9VDC
300mA Plugpack
Содержание VSWSC
Страница 3: ...2 INSTALLATION DIAGRAM ...
