01.11.22, 14:00
Firebox T80 Hardware Guide
https://www.watchguard.com/help/docs/help-center/en-US/Content/en-US/Hardware-Guides/firebox-t80-hardware-guide.html?cshid=10002
10/18
Before you remove an installed interface module, make sure that the interfaces
on that module are not enabled in the Firebox configuration. You cannot manage
a Firebox if an enabled interface has been removed.
To remove an installed interface module:
1. Power off the Firebox, and disconnect the power cable.
2. Loosen the two screws on the installed interface module.
3. Slide the interface module out of the expansion bay.
4. Put the removed interface module on an antistatic surface.
5. Install the expansion bay cover and tighten the two captive screws.
AC Power Adapter
The AC power adapter supplies power for the Firebox. Before you connect the adapter, verify that the
color band on the cord matches the color ring around the power plug on the Firebox.
The Firebox T80 includes a power cable to connect to the AC power adapter.
The suffix on the Firebox SKU indicates the type of power plug included with the device. Note that the
suffix is not restrictive – for instance, though tagged as “AU” for Australia, the Type I plug is also used
in China, New Zealand, and Argentina. If your country does not use one of these four plugs, use an
adapter with one of these plugs.
-US
A
US, Canada, Japan, Taiwan, Central America,
Some countries in South America, Philippines
-UK
G
United Kingdom, Ireland, Hong Kong, Singapore,
Malaysia, some African countries
-EU
C
Europe, Middle East, Korea, Indonesia, some
African countries
-AU
I
China, Australia, New Zealand
Restore Factory-Default Settings
SKU Suffix
Plug
Type
Used in regions
Photo
