01.11.22, 13:59
Firebox T40/T40-W Hardware Guide
https://www.watchguard.com/help/docs/help-center/en-US/Content/en-US/Hardware-Guides/firebox-t40-hardware-guide.html?cshid=10001
6/18
Rear
Rear view of the Firebox:
Serial Port (Console)
The leftmost port is an RJ45 serial console port. An RJ45 serial cable is not included with the
device.
USB Interfaces
The device includes two USB 3.0 interfaces. Connect a USB storage device for USB backup and
restore, or to store a support snapshot. For more information, see
Network Interfaces
The Ethernet interfaces have standard RJ45 connectors and support link speeds of 10, 100, or
1000 Mbps.
The Firebox T40 has five network interfaces. These interfaces are labeled 0/WAN, 1/LAN, 2, 3, 4-
PoE. Interface 4 is a PoE+ (Power over Ethernet) interface, compliant with the IEEE 802.3at
standard.
Interfaces 1 to 4 only support full duplex connections. Make sure the Firebox
interfaces and network devices you connect to these ports are set to auto-
negotiation or full duplex. Interface 0 supports both half and full duplex
connections.
Reset Button
This resets the device. To restore the device to factory-default settings, see
Power Switch
Controls the power supplied to the device. Move the switch to position
1
to power on the
device, or position
0
to power it off.
Power Input
An AC power adapter is included with your device. Connect the AC adapter to the device and to
a power source. Use only the supplied AC power adapter.
The red glow seen on the cover of some Firebox T40 devices is the LED on the
memory card inside the unit. For more information, see
.