6-16-19, JINGUMAE, SHIBUYA-KU, TOKYO 150-0001, JAPAN
TEL: +81-3-3400-6147 FAX: +81-3-3409-3156
4/4
ＩＭ０８７３
-
００
12. PC Settings
The dedicated setting tool of this product allows users to
specify the input/output parameters listed below.
Refer to the instruction manual for the setting tool for
further information.
(Refer to the instruction manual for the setting tool also for
the settable arithmetic function.)
Password
4 one-byte characters
Comment
16 one-byte characters
(8 two-byte characters)
Computing range
Selection between unipolar (0 to 100%)
and bipolar (-100 to 100%) for
input/output signal processing
(Default: unipolar)
Input scaling
(Input % range
adjustment)
Any value within input range (±120%
fs)
Input filter
Use or nonuse of moving average
processing
(Default: use)
Input low level cut
Low level cut value of input signal in %
(None or 0.00 to 120.00%)
(Default: none)
*Disabled at bipolar setting
Ratio and bias
(Functions
①
,
②
default
arithmetic setting)
Output in alignment relative to input
Specifying ratio (-9.999 to 9.999) and
bias (-999.99 to 999.99)
(Default: ratio of 0.500 and bias of 0.00)
Addition and
subtraction
(Function
⑤
default
arithmetic setting)
Output resulting from adding to or
subtracting from input Specifying
coefficient (-1000.0 to 1000.0) for each
input
(Default: 100.0)
Output scaling
(Output % range
adjustment)
Any value within output range
Voltage: ±120% fs of output range
Current: -20 to +120% fs of output
range
Output low level cut
Low level cut value of output in %
(None or 0.00 to 120.00%)
(Default: none)
* Disabled at bipolar setting
Startup delay time
Period from power-on to output start (0
to 99 sec.)
(Default: 0)
Simulated input/output
Simulated input/output in % or real
quantity
Data monitor
Input/output monitoring in % and real
quantity (This operation also can be
performed at settings.)
Initialization
Restored to factory defaults
*
The settings can be stored in the flash memory located in
the converter main unit. The write limit to the memory is
10,000 times at minimum.
(Retention period: 100 years at minimum)
* Do not write to the memory during operation.
(The product may unstably operate during writing.)
* The numbers within the parentheses such as function
①
and function
②
indicate the setting position in
“Conversion/Arithmetic Setting” for the setting tool. Refer
to the instruction manual for the setting tool for arithmetic
items and operator.
13. Guarantee
This product is guaranteed for 5 years after delivery. If a
failure occurs under normal operation during the guaranteed
period, contact your dealer or us as soon as possible.
We will collect the product and repair it free of charge, or
replace the product with new one.
We shall not be liable for use of this product that was
disassembled or modified or under abnormal conditions.
