2)Decimal point setting
The decimal point can be set to any position when the following
connector terminals are shorted. However, because the decimal is
not set prior to shipment, it must be set at the appropriate
position by the customer. Leading zero suppression must also be
set if required.
3)Input connection
Connect an input signal (BCD parallel signal) as the following
connector diagram shows. Use a short connection cable and 2-core
shielded cable near a signal source.
■Connector Connection Diagram
(-----connected inside)
4)latch
Latch terminal (T) Open or Connect to +VDO (18,V), BCD Input data
display.
Latch terminal (T) and 0V terminal (17,V)short, BCD Input data
display.
5)Decimal point common terminal(S)
This terminal used for decimal point selection only.
５.MAINTENANCE AND INSPECTION
5-1 Caution for maintenance
The storage temperature of this instrument should be within the
range -10℃ to +70℃ with relative humidity not higher than 60%.
If the instrument is used at a dusty location, withdraw the meter
assembly from the case at certain intervals and brush off any dust.
(The combination of dust and high temperature will shorten the
life of the meter parts.) The instrument case and bezel are
molded plastic, do not use a volatile-liquid such as thinner to
clean them.
６.WARRANTY
The warranty lasts for one year from the date of delivery. If this
product fails during this period and the reason is considered to
be clearly.
The manufacturer warrants to the original retail customer its
indicator to be free of defects in material and workmanship for
use under normal care and will repair or replace any.
７.AFTER SALES SERVICE
Under strict quality control measures, this product was
manufactured, tested, inspected and shipped. Should a defect in
manufacture or Workmanship be identified, please return the
product to our distributor or directly to us. It would be highly
appreciated if you could give a detailed account of the fault and
enclose it with the product.
MODEL AI-406 SERIES
ED-49981c
WATANABE ELECTRIC INDUSTRY CO., LTD.
6-16-19, Jingumae, Shibuya-ku, Tokyo 150-0001, Japan
Phone: (81)3-3400-6140
Homepage http://en.watanabe-electric.co.jp/
ASAHI KEIKI DIVISION
WATANABE ELECTRIC INDUSTRY CO., LTD.
6-16-19, Jingumae, Shibuya-ku, Tokyo 150-0001, Japan
Phone: (81)3-3400-6141
Homepage http://www.watanabe-electric.co.jp/en/
