INSTALLATION OF EZ MOUNT ASSEMBLY
STOPPER
REMOVABLE
SPLASH GUARD
SINK FLANGE
RUBBER SINK
FLANGE GASKET
SINK
SUPPORT RING
NOTE: ARROWS
INDICATING UP
CUSHION MOUNT
GROOVE
DISHWASHER
DISCHARGE INLET
HOPPER
ELBOW GASKET
END BELL
(ELECTRICAL
CONNECTIONS)
ELBOW
FLANGE
SCREWS
DISCHARGE
ELBOW
SERIAL NUMBER
LOCATED HERE
(Read completely before starting.)
NOTE: Pay close attention to the order of mount assembly parts,
as they have been correctly assembled by the factory.
Also, reference the cushion mount detail illustration below for
the proper orientation of the cushion mount.
A.
Disassemble mount assembly from disposer by turning mount ring
to the left (clockwise) and remove.
B.
Raise mount ring toward top of sink flange. Remove cushion
mount. Remove mount ring. You may want to practice installing
the cushion mount at this point before you are under the sink.
See paragraph "H."
C.
Unscrew support ring from sink flange and remove fiber gasket.
You are now left with sink flange and rubber gasket.
D. The rubber gasket is used instead of plumbers putty with
stainless steel sinks. Other sinks may require putty.
E.
If no putty is used, insert sink flange through rubber gasket into
sink opening. Do not rotate sink flange once it is seated.
F.
If you use putty instead of the gasket, form a ring around
underside of sink flange. Insert flange into sink opening, press
down hard to squeeze out excess putty. From under sink, trim off
excess putty flush with bottom edge of sink opening.
G.
From underneath sink, slip fiber gasket onto exposed sink flange.
With arrows pointing up, screw support ring onto the sink flange,
hand tighten until the sink flange will not move (see 1A). At this
point you may want to insert stopper in sink and fill with water to
check sink flange seal and insure there are no leaks.
‡ MOUNT RING
TIGHTENING EARS
* Batch feed stopper looks different than stopper
shown here (see Section 6).
** Not applicable to batch feed models.
‡ Mount ring may look different and may not have
tightening ears.
FIBER GASKET
**
*
YOUR DISPOSER COMES WITH ONE OF THE FOLLOWING MOUNT SYSTEMS
Proceed to the instructions for your type of mount system.
3-Bolt Mount System
EZ Mount System
SINK FLANGE
SINK FLANGE GASKET
PROTECTOR RING
FIBER GASKET
SINK MOUNT RING
MOUNTING SCREWS (3)
SUPPORT RING
MOUNT RING
TIGHTENING EARS
CUSHION MOUNT
SINK FLANGE*
SINK FLANGE GASKET
* An extended sink flange (Item # 3140) is
available for deep-well, cast iron sinks. (For
3-bolt mount only.)
1
INSTALLATION OF MOUNTING ASSEMBLY
