Wasp Wasp WDI7500, Руководство по продукции

Страница: 55 / 310

Enter/Exit Programming Mode
Product Reference Guide 45
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks
keyboard connection in order to transmit data to host. The selectable range
for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of
ten milliseconds. See page 237 in “References” for detailed information and
examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then
the barcode at left followed by the digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT barcode
again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can
then start again at the beginning.
~
CANCEL
DEFAULT
0A = Quiet Interval is

100 milliseconds
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See
page 239 in “References” for detailed information and examples for set-
ting this feature.
$CKBID
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then
the barcode at left followed by the digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT barcode
again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can
then start again at the beginning.
~
CANCEL
DEFAULT
00 = No Wedge Intercode Delay