Washtech CD180, Руководство оператора

Страница: 8 / 20

7/13/2022 8
Power
•
Electrical supply required is 3p/28A 415V 50Hz via switched outlet adjacent to machine.
NOTE: Equipment contains dangerous voltages and can be hazardous if installed or
operated incorrectly. Non –compliance with warnings or failure to follow the
instructions contained in this manual can result in loss of life, severe personal injury or
serious damage to property.
Chemical
•
Detergent and rinse aid pumps are not supplied with the CD100. We recommend you consult
your chemical supplier and/or a local chemical expert for their recommended detergent and
Rinse Fluid injector pumps.
NOTE: Commercial detergents can be hazardous – read instructions, store safely and
handle with care. Care needs to be taken when changing chemicals, ensuring that the
detergent is not accidentally connected to the rinse fluid inlet line.
NOTE: If uncertain, please consult a chemical specialist for assistance in selecting the
right chemicals and calibrating machine settings to suit this along with your unique site
conditions and requirements.
Waste
•
40mm connection required to point B as specified on install diagram. An S-trap must be fitted
on each of these points.
NOTE: Either copper or P.V.C. may be used for the waste connection – P.V.C. is more
resistant to some harsh detergents. Some authorities however suggest that copper is
required because the machine rinses at up to 90°C. It is important to note that rinse
water mixes with the 65°C wash water before discharge and then flows into the trap
where the water is further cooled before entering the drainage plumbing. We
recommend consulting your local authority to ensure your site remains compliant.
Installation Checklist
• Complete attached Installation Checklist to ensure machine is installed and running correctly,
and operator is familiar with operating procedures.
Installation Instructions
Washtech CD180 Operator Manual