www.warriorcustomgolf.com
5 |
P a g e
Table Assembly Instructions
Note:
No additional tools required for assembly, all nuts are pre-installed in the table. It is recommended to get
all bolts “Started” only. Once all bolts have been started check alignment of “top plates”, “leg panels” & “side
panels” before tightening bolts completely
.
1.
Install leg levelers (4) onto leg post by twisting in clockwise direction then stand
both legs in upright position.
2.
Position both side panels (2) on each side of the leg panels (make sure the
predrilled holes are on the top side), using (8)
5/16” x 1 ½”
bolts attach side
panels to leg panels.
(Heads Up-
you may find some or all of these bolts 1 ¾” in length
from factory. OK to use.)
3.
Attach goal boxes (2), using (4) 1/4
” x 1 1/2” bolts and washers.
4.
Insert metal plate into precut slots in goal box.
5.
Attach ball catch (1)
using (2)
1/4” x 1 ½” bolts
with washers.
6.
Install ball return runners (2)
a.
First hold the end of the “ball return runner” in one hand and with your other hand
press down firmly on the top edge with your index finger to create a “V” on the top
edge of the hose (see runner installation pics r1 & r2, page 6)
b.
With the goal box mounted, insert hose into the hole at the base of the goal box
until bottom edge of hose touches the mdf just inside the hole (this puts the hose
flush with the inside of the hole at the base of the goal box. (see runner installation
pics r3, page 6)
c.
Using your index finger, reach inside the hose and press up firmly removing the
“V” making the hose round again. This hose will stay in place and the ball will
drain perfectly to the “ball catch” every time. (see runner installation pics r4, page
6)
d.
Use this method to inserting hose into the “ball catch” as well.
7.
Place table top onto cabinet and secure using (6)
5/16” x 1 3/4” bolts with
washers.
8.
Attach corners blocks (4) to
side of table using (4)
5/16” x 1 1/4” b
olts with
washers.
9.
Attach top
plate (2) using (4)
1/4” x 1 3/4” bolts.
10.
Attach score beads (2) on to top plate using (4) #10 x 1 1/2” bolts.
11.
Place rods onto table top starting on any side.
Note:
In the event the bearings are
super tight or won’t easily go in it may be necessary to
prepare the hole with some emery cloth or a 1/2 round file to smooth out the inside diameter of
the hole and knock the burr off.
a.
– 1 man rods with 10“rod guard
b.
– 2 man rod with 15“rod guard