Page 3
For technical questions, please call 1-888-866-5797.
Item 57708
Setup
TO PREVENT INJURY:
Wear heavy-duty work gloves and
ANSI-approved safety goggles
during setup and whenever
handling the Hole Saws.
1. Find the circular slot in the
Backing Plate that corresponds
to the Hole Saw.
2. Align the three slots in the
Hole Saw with the three rails on the
Backing Plate, and press the Hole Saw
evenly against the Backing Plate,
see
step A
in illustration.
Note:
The Hole Saw will not attach
properly unless it seats evenly
against the Backing Plate.
3. After the Hole Saw is seated against
the Backing Plate, turn it clockwise
(viewed from grit side of Saw) firmly to
lock it in place, see
step B
in illustration.
4. Turn the Pilot Bit so that the flat on its
shank faces the same direction as the
Bolt on the side of the Backing Plate.
5. Insert the Pilot Bit into the center of
the Backing Plate so that the spade
tip extends through the middle of the
Hole Saw, see
step C
in illustration.
Note:
The Pilot Bit is properly positioned
when its shank extends out the back
of the Backing Plate 1-1/4
″
– 1-3/8
″
.
6. Tighten the Bolt on the side of the
Backing Plate to fasten the Pilot Bit,
see
step D
in illustration.
7. Open Drill’s Chuck (sold separately).
8. Place the Pilot Bit’s Shank
completely into the Chuck and
securely tighten the Chuck.
Backing
Plate
A
C
B
Hole
Saw
Pilot
Bit
D
