I N S T A L L A T I O N I N S T R U C T I O N S
7
Figure 7
9.
Once the brackets are loosely installed, with the help of two other people, lift the bumper into place.
10.
With the bumper in place loosely install using the bolt strips and 1/2" flat and lock washers with nuts (50246-HW). (Fig.8)
Figure 8
11.
Next hold the bumper into desired position on the truck. NOTE: WARN recommends a MINIMUM gap of 3/8” at the outer fenders and
headlights to prevent paint damage in normal operation.
12.
With bumper in position you can begin tightening all hardware. Tighten all fasteners fully, beginning with frame mounts. Then tighten
all mount-to-bumper fasteners.
