©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
98029A0
9. Secure bumper to support brackets with eight carriage bolts
(four on each side).
10. Remove license plate light housings from existing bumper
by squeezing the three retaining arms.
11. Install housings into corresponding side of the new bumper.
12. Remove trailer harness receptacle from existing bumper
by squeezing together the two metal retaining arms and
reinstall into new bumper in appropriate location.
13. Remove spare tire lock from existing bumper using vehicle’s
key. Insert into new bumper and lock into place.
14. If equipped, remove the four backup sensors and retainers
from existing bumper. To remove sensor from retainer, pry
apart sides of retainer while simultaneously pulling on the
sensor. Make sure to keep the small rubber grommet from
the sensor face as it will be reused. To remove retainer,
squeeze the retaining clips on either side of the retainer and
push out from bumper.
NOTICE
Be careful when removing sensors and sensor
retainer from bumper as to not damage.
15. Install retainers and sensors into corresponding position in
new bumper.
NOTE: If your vehicle did not come equipped with rear
sensors, use the supplied plugs to cover sensor locations.
15. Remove wiring harness from existing bumper. Install
harness in new bumper in the same orientation.
Cable ties
are provided to attach to mounting brackets and bumper.
Figure 11
Carriage Bolts
Figure 7