©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
2
87197 A1
N O T I C E
EQUIPMENT DAMAGE
• Always refer to the Installation and Specification Guide, supplied in the winch kit, for all wiring schematics and specific details on how to wire this WARN product to your vehicle.
• Never overtighten the j-bolt to the bracket. Doing so will pinch the winch cable against the bracket, damaging the cable.
• Always put the end of the actuator cable through the slot in the Termination Bracket. Terminating the cable through any other hole in the bracket will cause the bracket to not
function properly and will drastically reduce the life of the actuator cable.
Read installation and operating instructions thoroughly.
C A U T I O N
MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could lead to minor or moderate injury
• Always take time to fully read and understand the installation and Operations Guide included with this product.
• Never operate this product if you are under 16 years of age.
• Never operate this product when under the influence of drugs, alcohol or medications.
Read installation and operating instructions thoroughly.
N O T E S
B E F O R E Y O U B E G I N
T A B L E O F C O N T E N T S
Tools Required .......................................................................................................page 2
Torque Specifications
............................................................................................page 2
Parts List
................................................................................................................page 3
Installation
......................................................................................................... page 4-8
Tips/Troubleshooting
............................................................................................page 9
Maintenance/Care
................................................................................................page 9
• Before beginning plow mount installation, allow the engine and exhaust system to cool and disconnect the negative cable
from the battery.
Note: If a Warn winch mount is installed it does not need to be removed
to install this plow mount.
Note: Loosening the factory front tube guard bolts may aid in installation of this kit. Be sure to
Re-tighten factory bolts when installation is complete.
T O O L S R E Q U I R E D
• Ratchet and Torque wrench
• Sockets: 10mm, 12mm, 13mm, 17mm
• Wrenches: 10mm, 12mm, 13mm, 17mm
• 5mm Hex Wrench
• Screwdrivers: Slotted, Phillips
• Sidecutters, Saw or Utility knife
T O R Q U E S P E C I F I C A T I O N S
6mm - 13 N-m (10 ft-lb)
8mm bolts - 16 N-m (12 ft-lb)
8mm U-bolts - 13 N-m (10 ft-lb)
10mm bolts - 47 N-m (35 ft-lb)
