WARN® INDUSTRIES
PAGE 5
79968A3
Figure 7
Figure 8
sleeve toward the edges of the plow blade. Ter-
minate with a skid pin by running the pin through
the skid sleeve hole and through the desired skid
hole. Be sure to lock the skid pin when completed
to prevent losing the pin and skid during plowing.
NOTE: Set the skids higher than the edge of the plow
blade for gravel and decorative surfaces. Set
the skids at plow edge level for pavement and
concrete surfaces. Failure to use the skids
can result in scratches to the roadway surface
and reduced wear bar life.
9. In order to use your winch to raise and lower the
plow blade, you must first attach the plow assem-
bly to the vehicle mount. (Please refer to vehicle
mount installation instructions for proper mounting
and use of the vehicle snow plow mount).
Swing the rope guide up and run the winch rope
through the guide. Close the rope guide and se-
cure it with safety retainer pin. The winch rope
should now be fully captured by the rope guide.
See Figure 8. Attach the winch rope hook to the
rear cross member between the tubes. Figure 8
shows installation of 92100. For use on 78100,
route winch rope through the rope guide as shown
in Figure 8. Hook should be secured to cross
member at the rear of tube assembly.
Installation is now complete, please proceed to the
next section.