WARN INDUSTRIES
PAGE 11
73465 A2
Figure 18 LH Cross Member Bracket installed
20. Repeat for the LH Cross Member Bracket. Position the Cross Member Bracket as shown in
Figure 18
if the vehicle is equipped with the transmission cooler line bracket. Insert a 1/2 x 2 1/4” bolt. Install a 1/2”
flat washer, lock washer and nut.
Note: No flat washer is needed under the bolt head if equipped with
transmission cooler line bracket.
Do not tighten yet.
21. Insert a 1/2 x 1 1/2” bolt and flat washer through the bracket into the slot in the back of the bumper.
Install a 1/2” flat washer, lock washer and nut. Do not tighten yet.
Repeat steps for the other Cross Member Bracket.
22. Insert a 7/16 x 1 1/2” bolt with flat washer through each of 3 slots in the Bumper Gusset Plate, into the
Frame Brackets. Install a 7/16” flat washer, lock washer and nut on each. Do not tighten yet.
23. Level the bumper and tighten the eight flange nuts.
24. Tighten the 1/2 x 4” frame bolts then the 12mm Lower Frame Bracket bolt.
25. Tighten the Bumper Gusset Plate hardware.
26. Finally, tighten the Cross Member Bracket hardware. Do not over tighten the 2 1/4” bolts as this may
distort the cross member.
27. The plastic inner fenders can be tucked up into the rear of the bumper and zip-tied to the body mount
studs or trimmed to the desired shape.
Figure 19
28. Reinstall the skid pan and grille with the original fasteners.
LH Cross Member Bracket
No flat washer
needed under bolt
head if equipped with
transmission cooler
bracket
