Page 5
72489 A0
Figure 9 Completed Winch Installation
Please refer to the Installation and Specification
Guide, supplied in the winch kit, for all wiring
schematics and specific details on how to wire
the winch to the ATV.
Notice
WARNING
Tighten all nuts and bolts securely. Failure to
check all nuts and bolts prior to use can result
in product failure which can lead to vehicle
damage and operator injury or death.
8.
Attach the fairlead mounting bracket to the front
bumper using four 1/4-20 x 1 1/8” x 1 3/4” U-bolts
(B1), eight 1/4” flat washers (B2) and eight 1/4-20
lock nuts (B3), figure 8. Tighten the 1/4” U-bolts to
a recommended torque of 10 N-m (7 ft-lbs).
9.
Attach fairlead to the fairlead mounting bracket
(A1), figure 9. Use the two supplied 3/8” dia bolts,
nuts, and lock washers provided with the winch
kit. Install the lock washers and nuts on the
fairlead side. Tighten the two 3/8” dia bolts to a
recommended torque of 34 N-m (25 ft-lb). Note:
a roller fairlead is shown in the instructions. If your
winch came with a casted hawse fairlead it will
attache in the same location, use the hardware
that came in the winch to attach it to the bracket.
Figure 8 Fairlead mounting bracket Installation
