WARN INDUSTRIES
PAGE 3
60003 B2
II. INSTALLATION CONTINUED
4.
Remove the bracket bolts from the original bracket. Install the winch mounting bracket to the
original bracket using the 5/16-18 bolts, washers and lock nuts,
Figure 4
and
Figure 5
.
Do not tighten fasteners at this time.
5.
Install the winch onto the mounting bracket with the two lower bolts and lock washers,
Figure 6
(upper winch mounting bolts will be mounted later with the plastic brush guard and fairlead).
Note: The motor should be on the “right” side, when looking at the front of the ATV.
Torque lower winch bolts to approximately to 21 ft-lbs.
6.
Install and tighten upper frame bolts, bracket bolts and lower frame bolts to an approximate
torque of 21 ft-lbs,
Figure 7
.
Figure 5
Figure 6
Figure 4
Figure 7
