©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
97933B1
12. If equipped, remove the four under-ride bar nut-plates (two
each side).
13. Unclip and move aside fog light connector.
14. Install Frame Brackets left (A3) and right (A2).
NOTE:
Brackets are not symmetrical, check exploded view for proper
orientation.
Use four 5/8-11 bolts, washers, lock washers and nuts on the
outside of each bracket. Repeat for other side.
Use two 1/2-13 X 1-3/4” bolts, washers, lock washers, and
nuts on the top of each bracket. Repeat for other side.
See page 2 to torque fasteners to specified torques.
NOTE: It may be necessary to lightly tap the frame bracket
into place. Be very careful not to damage any vehicle parts
while installing the brackets.
Intercoolers and hoses are close to the brackets so take care
as to not damage, kink, or cut the hoses during installation.
NOTE: Protect any tubes and wires near brackets from
rubbing on brackets or fasteners.
15. With assistance, place bumper (A1) in position and secure
to frame bracket with four 1/2-13 X 2” bolts, washers, lock
washers and nuts. It may be necessary to use a combination
of spacers (A4) and (A5) to center bumper or fill space
between frame brackets and bumper.
For the two lower holes, use 7/16-14 X 2” bolts, washers, lock
washers and nuts to fasten bumper to frame brackets.
Refer to exploded view on page 3.
Repeat for other side.
Figure 11
Figure 12
Nut plate
Fog light
connector
Figure 7
B1,B2,B3,B4
(both sides)
B6,B7,B8,B9
(both sides)
B5,B7,B8,B9
(both sides)
B10,B12,B13,B14
(both sides)
