Warmup DWS300, Руководство по установке

Страница: 11 / 21

Installation step 2
Mark the heater position on the floor.
Calculate in square metres the size of the area to
be heated. Then, using the sizing guide on the back
of the manual, read off the wire spacing and perimeter
distances to correctly fit your heating wire into the
space available.
Using a fibre tipped pen, mark a start point as close
as possible to the power supply, but no further than
2.5m from it.
Mark all the outer corners of the heated area observing the
perimeter distances previously read off the sizing guide
and join the corners up to form a marked out perimeter.
Mark up the spacing intervals for the heating wire
following the sizing guide.
The spacing must be a minimum of 50mm and at no
time should the heating wire be less than 40mm from
the wall.
11