3
Safety Information
Step 1 - Installation
The 6iE mini must be installed by a qualified electrician. It requires a
permanent 230 V AC supply from a 30mA RCD or RCBO protected circuit
in accordance with the current edition of the BS7671 Wiring Regulations.
Isolate the 6iE mini from the mains supply throughout the installation
process. Ensure that wires are fully inserted into the terminals and
secured, free strands should be trimmed, as they could cause a short-
circuit.
Install the 6iE mini in an area with good ventilation. It should not be
beside a window/door, in direct sunlight or above another heat generating
device (e.g. radiator or TV).
Ensure the distance from your router to the 6iE mini is not excessive. This
will ensure the wireless connection is not subject to range or interference
issues once installed.
q
q
q
q
For bathroom installations the 6iE mini MUST be mounted outside of
Zones 0, 1 and 2. If this is not possible then it must be installed in an
adjacent room, controlling the rooms using the floor sensor only.
The 6iE mini and its packaging are not toys; do not allow children to play
with them. Small components and packaging present a risk of choking or
suffocation.
The 6iE mini is suitable for indoor use only. It must not be exposed to
moisture, vibrations, mechanical loads or temperatures outside of its
rated values.
For safety and licensing reasons (CE/UKCA), unauthorised change and/or
modification of the 6iE mini is not permitted.
q
q
q
q
Isolate the thermostat supply from
the mains supply.
Install a 50 mm deep electrical back
box in your preferred thermostat
location. Pull wires (heater, supply
and sensor(s) through back box
and complete terminal wiring.
Unclip the display from the power
base.
Release the display as shown.
2
1
1
3
2
4
230 V AC:
50Hz
Heaters. Max. 16A
(3,680W)
Sensor
