Overheat protec on
The heater is equipped with a protec on that turns off the heater in case of
overhea ng. If it worked, turn off the heater, unplug the device and let it cool down
completely. Check that the air inlets or outlets are not blocked, then try to restart the
heater.
If the heater does not work or the safety device turns it off again, return the heater to
the service center for inspec on and possible repair.
Tilt sensor
The device is equipped with a lt sensor located on the PCB board. When the heater
lts about 15 degrees, the power will be automa cally turned off.
If the temperature set on the heater is 1°C higher than the current one in the room,
the heater will be turned on and the icon will appear on the display .
Ac va on of the heater
Press and hold the bu on to ac vate the child lock. Press and hold the bu on
to turn off the child lock. The func on works both in standby mode and when the
heater is on.
Child lock
Press and hold the bu on to ac vate the open window func on. The ac va on
of the func on is confirmed by displaying the icon on the device's display. To
disable the open window func on, press and hold the bu on The opera on of
the open window func on is if the temperature in the room drops by 5°C within 20
minutes, the heater will stop hea ng and the icon will flash on the display. To
restore the heater's opera on, press and hold the bu on . A er a while, the
open window icon will stop flashing and the heater will operate in the mode before
the func on was ac vated.
Open window func on
Ac va on of the standby mode for connec on with Wi-Fi
Connec ng the heater to the mobile applica on via Wi-Fi is possible when the
standby mode for connec ng to the Wi-Fi network is ac ve. This is confirmed by a
flashing icon on the device's display. To enter the Wi-Fi standby mode, press and
hold the bu on . A er about 5 seconds, the flashing icon will appear on the
display. More about connec ng to a Wi-Fi network in the chapter Connec on set
up/Wifi control
40
Содержание EWE+
