Warmlite WL45038, Инструкция по эксплуатации

Страница: 10 / 16

10 CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056
Placing the Decorative Pebbles:
This unit comes complete with decorative
pebbles, to be placed on the inside of the
appliance.
To place the pebbles inside the fire, begin by
opening the front panel. To do this, locate the
2 fixing screws on either side of the unit, near
the bottom bracket, and use a screwdriver to
loosen them by turning them anti-clockwise (to
the left). Repeat this process with the 2 screws
on the opposite side of the fireplace, so that all
4 screws are loose.
When all 4 screws have been loosened, remove
them to one side and carefully pull the front
glass panel of the fire away from the main body
of the unit. You can now place the decorative
pebbles inside the fire.
Loosely scatter the pebbles over the main inner
area of the fireplace. Once you are happy with
the arrangement, place the front panel back
into position and insert the fixing screws back
into their respective slots on either side of the
unit. Use a screwdriver to tighten each screw
into place by turning it clockwise (to the right).
so that the glass panel is secured and cannot
come loose.
NOTE: Ensure the glass panel is firmly secured
into place before attempting to use the fire.
Your fireplace is now ready for use.
USING YOUR APPLIANCE
Turning the Appliance On and Off:
• To turn the appliance on, first plug it into a
mains outlet.
• Once the appliance has been plugged
in, press the Power ON/OFF button on
the remote control or the unit’s control
panel to turn the appliance on. A red LED
indicator will light up to show the unit has
been turned on.
• Press this button again while the fireplace
is in operation to turn it off.
NOTE: When using the remote control, first
ensure the Standby switch located on the top
right-hand side of the appliance is switched on;
otherwise, the remote operation function will
not work.
NOTE: When using the remote control to
operate the unit, there will be a delay between
the button press and the corresponding
function being activated. DO NOT press a
button more than once every two seconds to
ensure optimal operation.
Auto Function:
This fireplace is equipped with an Auto
function, in which the LED flame effect will
automatically change at 10-second intervals.
Long-press the Power ON/OFF button on the
remote control or the unit’s control panel to turn
the Auto flame function on.
Heat Selection:
This fireplace offers a choice of two heat
settings: Low (1000W) or High (2000W).
Each of these two settings is represented by
a corresponding button on the remote control
and the unit’s control panel.
To select your preferred heat settings, carry out
the following instructions:
• To select the Low heat setting, press the
1000W button on the remote control or
the unit’s control panel. Press this button
again to turn the heating function off.
• To select the High heat setting, press the
2000W button on the remote control or
the unit’s control panel. Press this button
again to turn the heating function off.
Setting The Time And Date:
• This unit is equipped with a built-in timer,
which allows for programmable, hands-
free timed operation. To make use of the
unit’s timer, begin by setting the correct
time and date.