8
CUSTOMER SUPPORT TEAM::
+44 (0) 333 220 6056
HANDLING
Before continuing any further with the
installation of this fire please read the following:
• Two people should be sufficient to lift the
fire.
• When lifting always keep your back
straight. Bend your legs and not your
back.
• Avoid twisting at the waist. It is better to
reposition your feet.
• Avoid upper body / top heavy bending.
Always bend from the knees rather
than the waist. Do not lean forward or
sideways whilst handling the fire.
• Always grip with the palm of your hand.
Do not use the tips of fingers for support.
• Always keep the product as close to the
body as possible to prevent unnecessary
and undue strain on the body.
• Use gloves to provide additional grip.
• Always use assistance if required.
UNPACKING THE PRODUCT
The unit is supplied in a single package
carton. Carefully unpack the product using the
following procedure:
• Ensure that the product is in the correct
position with the carton wording legible.
• Remove the straps and sleeve.
• Carefully lift the fireplace out of the box.
• Remove the protective packaging and
bag from the suite.
• Locate the fixing pack and put aside.
• Carefully remove the protective film
covering the fire.
INSTALLATION
IMPORTANT:
Do not connect the appliance
until it is properly fixed to the wall and the
instructions have been read fully.
Ensure the minimum distances are
observed.
1. The fire is designed to be permanently
fixed to a wall at a minimum height
of 300mm. The wall bracket must be
fitted horizontally and the cable routed
to the bottom right of the fire. A height
of 600mm from the floor to the bottom
of the wall fire is recommended for
optimum viewing of the fuel bed.
2. Use the bracket as a table template
and mark five drill positions on the wall.
Ensure that these holes are all level.
3. Put the bracket aside and drill holes
with a depth of 35mm using a 2mm
pilot drill bit & 8mm drill bit.
4. Clean the holes from dust and debris
and insert one plug in each hole. Make
sure the edge of each hole is flush with
the surface.
5. Hold the bracket in position and fix it in
place with screws.
475 mm
330.5
mm