Warmlite WL43006Y, Инструкция по эксплуатации

Страница: 7 / 12

7 www.warmlite.co
ASSEMBLY
1. Fit the Castor units to the cross bars.
2. Turn the radiator upside-down on a
scratch-free and stable surface to
prevent damage to the paint finish or your
floor surfacing.
3. Fit the two Castor units to the radiator
by placing the U bolts between the
outermost fins on each side of the
radiator.
4. Securely fasten the two Castor units onto
the radiator by screwing two Wing Nuts
onto each Foot.
Once turned to the upright position, allow the
oil to settle and wait for at least half an hour
before using.
USING YOUR APPLIANCE
Note: It is normal for the heater to emit some
smell and fumes when it is turned on for the
first time or has been turned on after a long
period of non-use. This will disappear after the
heater has been on for a short while.
1. Set the radiator thermostat to the minimal
position. Make sure the wall socket power
switch is in the “OFF” position. Insert the
plug to the power supply.
2. Set the power switch to the “ON
“position.
3. Turn the thermostat control clockwise
all the way round, until you hear a click.
This sound indicates that the oil heater
is activated and the indicator is ON.
Continue turning the thermostat control
clockwise to its highest setting.
4. When the indicator light turns ON the
heater will activate. The indicator light
turns ON and OFF repeatedly during
use. This is normal and shows that the
thermostat is keeping the radiator at your
desired temperature.
• Switch 1 = Low Heat
• Switch 2 = Medium Heat
• Both Switches = High Heat
1
3
4
2