Warmlite WHITBY 2KW, Инструкция по эксплуатации

Страница: 11 / 16

11 www.warmlite.co
TROUBLE SHOOTING
Safety Cut-Out device:
To ensure against the potential hazard caused by
blockage of the air outlet, this unit is equipped with
an automatic overheat safety cut-out device. When
the device is activated the heater will not operate. If
this occurs, the unit can be reset using the following
procedure.
1.
Turn the fire off by depressing the on/off switch on
the unit.
2. Unplug the power cord form the electrical mains
supply socket and leave it disconnected for at
least 15 minutes.
3. Ensure that the air vents are free from obstruction.
4. Plug the power cord back into the mains socket.
5. Turn the fire back on.
6. If the fire fails to operate, check the fuse in the
plug.
7. If the fuse in the plug is OK and the fire is still not
functioning, contact a qualified person.
Symptom Corrective action
No operation
No fan.
Check that the
safety cut-off has not
activated.
Check that the unit is
plugged into the mains
and that the On/Off
switch has been set to
the ON position.
Ensure the temperature
control dial is not in the
OFF position.
Check that the fuse
is working. If broken,
a replacement is
necessary.
No light Check that the LED
is working. If broken,
a replacement is
necessary.
CLEANING AND CARE
WARNING! Always disconnect from the mains supply
before cleaning the wall fire.
CAUTION! Allow the product to completely cool before
handling or cleaning it.
•
Never use abrasive cleaners and chemical agents
as damage may occur to the finish.
• For general cleaning use a soft clean duster.
• The glass viewing screen should be cleaned
carefully with a soft cloth.
• Do not allow water or other liquids to run into the
interior of the product, as this could cause a fire
and/or electrical hazard.
• We also recommend the periodic cleaning of this
appliance by lightly running a vacuum cleaner
nozzle over the guards to remove any dust or dirt
that may have accumulated inside or on the unit.
Maintenance
• Before any maintenance of the exterior of the
fireplace, disconnect the unit form the power
supply and leave until cool.
• Remote control battery replacement: this remote
control uses 2x1.5V AAA battery. Ensure the
batteries are installed correctly in the remote
control.
• This product does not use a standard bulb for its
flame effect. The appliance uses an electronically
controlled LED system to create the flame effect
therefore no parts need to be replaced. There
are no user-serviceable parts on this appliance.
Under no circumstances should the appliance
be serviced by anyone other than a qualified
electrician.
WARNING:
DO NOT IMMERSE ANY ELECTRICAL PART
OF THE APPLIANCE IN WATER SUCH AS
MOTOR UNITS OR PLUGS.
PLEASE SEE CLEANING SECTION FOR
FURTHER INSTRUCTIONS.