5 September 2019
All dimensions are in mm
Copyright
20
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
•
After checking the pressure, turn the unit off, remove manometer from the test point and tighten the test point screw. Ensure to
check for gas leaks.
•
Ensure power is off & reconnect modulator harness connection in the main harness.
•
Turn the appliance on and off a few times to check ignition.
•
When you are satisfied that the appliance is working correctly, fit the front panel assembly back to the gas burner.
NOTE:
Ensure you peel the Protective Plastic Coating from any stainless steel components if fitted.
All burner aerations are factory preset and cannot be adjusted.
If you are unable to get the unit to operate correctly, refer to troubleshooting before contacting your local service contact.
It may take approximately 2 hours of operation for the coals/logs or river rocks to achieve their full flame pattern and glow.
During the initial burn period, some smoke and smell may be experienced. Because of this, run the appliance on the high position in a
well ventilated room until the fumes dissipate.