8
Functional Status Indicators:
‘Heating mode’:
Indicator B will be lit up which means heating mode is on.
‘Memory function’:
In the event of a power failure, the memory function will remember the
previous settings when coming on again.
Forced output:
Make sure the receiver’s off and then press down the “Power button” for 8
seconds. Indicator A will light up and if you want to exit just simply press the “power button”
once more.
Transmitting signal:
When an instruction has been inputted into the controller, indicator
C will flash 2 times on the receiver that means the transmitting signal is communicating
successfully.
Temperature Limitation:
When the temperature is below 5
℃
, the forced output will start to act as anti-frost
protection. When the temperature is up to 8
℃
, the forced output will be stopped. In the
event indicator B is rapidly flashing, this means the external sensor has been broken.
Setting the temperature limit - When the receiver has been running, press down the
“Power button” for 3 seconds, then the indicator A (Red LED) will chance to the green LED
flashing. This now means you can set the upper temperature limit for the controller.
•
Limit 30
℃
:
The green LED (indicator B) will be flashing.
•
Limit 40
℃
:
The yellow LED (indicator C) will be flashing.
•
Limit 55
℃
:
The green LED (indicator B) and the yellow LED (indicator C) will be
both flashing.
To then confirm your selection
-
Press the “Power button” to select the option which is one
of the three modes.
Make sure the receiver’s off, and
then press “Power button” for
3
seconds, the indicator C will be
illuminated.
Make sure the thermostat is
off and
press down the button
and
for
se
3
conds, admitting into coding
status.
If connecting is successful,
the
indicator C will flash 6 times and
then
a
brief
code will appear
confirming
connection
being
successful.
If coding has been
unsuccessful,
the thermostat will keep the original
coding value and you will need try
again.
01205 821 796
www.warm4less.com
EASI
INSTRUCTION
MANUAL
8
