Warm Tech WTRBH1507, Оригинальное руководство пользователя

Страница: 21 / 30

21
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and
will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped bolt to the
U-facing flange between first and second fins (near the front cover).
3. To attach the castor mounting plate to the radiator body, you should insert the threaded
ends of the U bolt in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5
、
Screw off spherical nut from the castor, align the shaft to the hole of the castor mounting
plate, insert in, and screw on the spherical nut.
6
、
Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the rear castors.
Note: the rear castors must be mounted between the end two fins.
INSTRUCTIONS FOR USE
1. Before using the heater, make sure that it is on a flat and stable surface. Damage may occur
if it is placed on an incline or decline.
2. Set all the controls to OFF position and insert the plug into a socket-outlet with well
grounded. Be sure that plug fits firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch the heater on as follow:
the switch I for low heat, the switch II for medium heat and both switches on for high heat.
4. When your room reaches the desired temperature, now slowly rotate the thermostat knob
counter clockwise until the pilot light goes out. The thermostat can now be left at this setting.
As soon as the room temperature has dropped below the set temperature, the unit will switch it
self on automatically until the set temperature has been reached again. In this way the room
temperature remains constant with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob clockwise to
raise the temperature, or counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when parts of
the heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove plug from the
socket-outlet.
OPERATION
1. The room temperature can be adjusted by the thermostat. Simply turn the thermostat knob