21
MOUNTING AREA
Note:
This product is suitable for mounting in Zone 3 or the safe zone of a bathroom ( or similar ) only if
a permanent connection to the mains supply is made in accordance with the requirements of the
building Regulations ( including the wiring Regulations).
If in doubt, consult a qualified electrician.
1) HEATING PERPARE
Set time
Before turn on the heater,set the time as right time.Press remote control “
” button,light on
control panel,it shows current Room temperature. WEEK Press “Set” button one time,“
”lights
on,press “
“two buttons set the week from 1--7 (1=Monday,2=Tuesday...7=Sunday ect.)
HOUR Press “Set” button again,“
” lights on, “
two buttons set the Hours from 01--
00(01=1 o’clock,02=2 o’clock...00=24 o’clock ect.)
MINUTE Press “Set” button again,“
” lights on, “
two buttons set the Minutes from 00-
-59(01=1 Minute,02=2 Minute ect.)
PS:Press “Set” button,screen shows number will twinkle 5 seconds,you should operate in
time ,otherwise appliance will get back to standby.
(Appliance will keep the right time until power off)
2) GENERAL USING OPERATION
1.Turn the heater ON by pressing the “
”
main button with the light is on.The unit will blow the
cold air
and “
” light is on.
2.Pressing the “
” button ,the unit will blow the warm air and both“
”and“
” lights are on.
3.Pressing the “
” button second times,the unit will blow the hot air and both “
”“
” lights
are on.
4.Pressing the “
” button Three times,the unit will blow the cold air and “
” light is on.
5.Pressing the “
” button,the unit will set timer from “01-24” and “
” light is on.”00” means
closed timer.
