890557_d•en•01.07.2014
We reserve the right to carry out improvements
26
Wisotronic 1-channel
Operating instructions
The
header
is visible in all menu levels. The date and time are shown at the
top (
A
). Various symbols are shown between the date and time, depending
on the state of the Wisotronic (
B
,
). Below this,
the menu in which you are currently located (
C
) is identified.
The currently measured weather data of the sensors (
D
) appear in the
display field
below this. In addition, you will see whether you have activated
the Automatic features (
E
) and whether the "Absent" switch has been
pushed on the control panel (
F
).
The
footer
(
G
) always shows which functions the four buttons below it cur-
rently have.
The following functions are assigned to the buttons in the start menu:
The [
Main
] function button leads to the main menu, where you can access
scenes, channels and groups. With the [
Auto
] button, you can switch the
automatic modes of the Wisotronic on and off. The [
Absent
] button is used
to activate the Absent function. The [
Meas. val.
] function button takes you
back to the start menu, where the measurement values, causes, malfunc-
tions and histories are displayed. Histories are graphic presentations of the
chronological sequences of measured values that can be conveniently traced
with the cursor (
see Chapter 8.2 on page 100
).
5.1.1 Status display
The symbols in the header indicate the following states of the Wisotronic:
Data must be loaded into the devices
Service mode
A fault occurred. Fault messages are displayed in the fault menu
([
Start menu
] > [
Measured values
] > [
Faults
]).
"Leave" function is activate
"Absent" function is active
Netting started