WAREMA Wisotronic, Руководство по установке

Страница: 101 / 108

warema_890558_alhb_en_v5•2022-02-01 We reserve the right to carry out improvements
101
Maintenance
14 Maintenance
There are no parts within the device that require maintenance.
In the event of a fault, the cabling and power supply must only be checked
by a certified electrician.
Also follow the specifications in the operating instructions of your sun shad-
ing product and the other controlled devices.
14.1 Cleaning
Clean the acrylic glass front panel occasionally with a soft damp cloth.
Steam or high-pressure cleaners, abrasive sponges, abrasive agents, and
solvents such as alcohol or benzine may not be used.
CAUTION
When performing cleaning activities are necessary on the Wisotronic, on the
sun shading product itself or in the immediate vicinity of the sun shading
product, first de-energise the unit and secure it against reactivation.
15 Liability
Failure to comply with the product information in these instructions and use
of the unit in a manner that contravenes its intended use and purpose may
result in the manufacture refusing to honour warranty claims for product dam-
age. In this case, liability for consequential harm to persons or damage to
property will also be excluded.
Follow the instructions in the operating instructions of your sun shading prod-
uct. Liability is also excluded for damage to the sun shading system resulting
from operation under icy conditions.
The device meets the requirements on interference resistance and interfer-
ence emission for use in residential and commercial areas.
16 Information for the
user
Receiver for the control of sun shading units
When used as intended, the device meets the basic requirements stipulated
in the following EU guidelines and harmonised standards:
Directive on radio and telecommunications terminal equipment and the mu-
tual recognition of their conformity 1999/5/EC(R&TTE)
EMC directive 2004/108/EEC
Low voltage directive 2006/95/EEC
The declaration of conformity can be reviewed at:
http:// www.warema.de/ce
The device has been tested for compliance with the legal regulations for
interference emission according to DIN EN 61000-6-2:2006-03 and for the
interference resistance according to DIN EN 61000-6-3:2007-09. The re-
quirements in conjunction with the prescribed supply lines and sensors of the
manufacturer are positively met or exceeded.