Maintenance
2023752 [Rev. 0 - en]/2018-05-04
Page 9 | 14
Performing rough cleaning
Clean the complete product of
loose dirt (e.g. dust,). Do not
forget the opening of the guide
for the curtain. A whisk broom/
broom or vacuum cleaner can
be used for this.
or
If the product is outside
(outdoors), alternatively rinse off
loose dirt with fresh water with a
low water pressure.
Performing detailed cleaning
Cleaner
Prepare the bucket with
water and cleaning agent.
Note the dosing quantities
specified by the cleaning agent
manufacturer.
Moisten the microfibre or
sponge.
Clean the product components
with a wiping motion. Repeat
the procedure if necessary due
to the degree of soiling.
Clean the drainage gutter and
drainage pipe to remove any
blockages, e. g. due to leaves.
Remove the detached soiling
before drying.
Drying the product
extend the product into the lower limit position.
INFO
To avoid calcium edges around dried water droplets,
the surfaces of the product can be rubbed dry using
a microfibre cloth or cotten cloth.
Inspecting the product during cleaning
Operate the product and inspect the operating elements
for visible wear and damage (visual check).
Check the mounting substructure for damage (visual
check).
INFO
Wear and damage to the operating element
or product as well as damage to the mounting
substructure may impair the product and result in
secondary damage.
Take the product out of service.
Have any damage repaired by a qualified
specialist.
4.2
Maintenance
CAUTION
Risk of injury from lack of product knowledge!
Have service tasks performed by a qualified
specialist.
The product must be maintained at least once a
year.
The maintenance tasks may only be performed
by a qualified specialist. We recommend signing a
service contract.
The WAREMA warranty becomes invalid if the unit is
not maintained properly at least once a year.
WARNING
Risk of injury through irregular maintenance!
Operating safety may be seriously impaired and the
product may fail. Persons may become injured from
contact with damaged parts.
Have the product checked regularly by a
qualified specialist for signs of wear and
damage, e.g. to electrical lines.
Do not operate products in need of repair.
Check the product for visible wear and damage. If
necessary, make a recommendation to the owner.
Check that the fixation of the bearing elements (e.g.
consoles, guide elements) is properly seated. If
necessary, make a recommendation to the owner.
Perform a functional check and check the limit positions
of the product. Adjust the setting of the limit positions
if necessary (see the installation instructions and/or
setting instructions).