7
890464_k•en•2019-10-01
We reserve the right to carry out improvements
2. Test the sun control
Move the sun shading system manually to its middle
position.
Move the "Wind" switch on the weather station to the
TEST position and the "Brightness" switch to position
"1".
Trigger a wind alarm: Simulate a gust of wind on the
wind sensor. The wind alarm was triggered when the
sun shading system moves up.
After 1 or 2 minutes the sun shading system must
move down again.
If the sun shading system does not move down, the photo
sensor may not have been learned in. To test whether the
photo sensor was learned into the receiver correctly:
Move the "Brightness" switch on the weather station to
any position other than "OFF". Move the sun shading
system down slightly and press the
button on the
weather station.
If the sun control was learned in correctly, the sun
shading system moves down for approx. one second.
If the sun shading system does not move during this test,
the sun control was not learned in. Learn in the sun control
again separately (see „Learning in functions individually“).
3. Test the precipitation monitoring function
Move the sun shading system manually to its middle
position.
Wet the sensor surface of the precipitation sensor
slightly with water.
The status LED flashes red. The sun shading system
should now move up.
If the sun shading system does not move during this
test, precipitation monitoring was not learned in. Learn in
precipitation monitoring again separately (see „Learning in
ITNCE
R
In this test, EWFS tubular motors do not re-
spond when the
button is pressed.
Learning in functions individually
If problems arose when learning in the weather station of a
sun shading product, the functions can be learned into the
sun shading product separately later on.
Learning in wind monitoring individually
Perform the following steps consecutively:
Place receiver 1 into learn
mode:
Take the hand-held
transmitter into which the
master channel was learned
(I), press and hold the learn
button, external roller blind 1
waves once, release the but-
ton.
Set the switches on the
weather station:
The "WIND"
switch is located in any posi-
tion other than "TEST", and
the "Brightness" switch is in
the "OFF" position. Precipita-
tion monitoring is switched
off (the LED does not light up
green permanently).
Learn in wind monitoring:
Press the
button on the
weather station and hold it
until the sun shading system
stops moving (the external
venetian blind waves once).
Release the button. The
weather station is now an
auxiliary channel for external
venetian blind 1. Wind moni-
toring was learned in at the
same time.
End the learn mode:
Take
the hand-held transmitter with
the master channel (I) and
press the "Up" or "Down" but-
ton.
Wind monitoring is now learned into the sun shading
product.
Ι
Ι
