3
890463_k•en•2019-10-01
We reserve the right to carry out improvements
Remove the thin (triangular) pieces at the top and
bottom edge of the mounting plate using a wire cutter
*
).
Pass the included steel cable ties through the
mounting plate openings as shown. The cable tie
closures must face outward.
Attach the weather station to a securely mounted pole.
Ensure that it is oriented correctly and that the cable is
not pinched during installation.
Turn both ends of the cable tie inwards, one at a time,
using needle-nosed pliers. Check that the weather
station cannot be turned.
Tighten the screw on the joint.
Iperating elements
6
7
9
8
10
Fig. 7 Operating elements, view from below, factory setting
6
Wind:
Wind speed limits can be preselected using
this switch.
7
LCED:
Flashes green when the L button is
pressed (or red if the battery voltage is low). Flashes
red (three at a time) while a wind alarm is active.
8
Brightness:
Brightness limit values can be
preselected using this switch.
9
Learn button:
For learning the weather station into
a receiver. This button must be held down until the sun
shading system waves once. If the button is held down
until the sun shading product stops moving, the wind
and brightness evaluation is learned into the receiver
as well.
10
In/off button:
To switch the weather station on or
off, press and hold the button for at least 5 seconds
until the status LED lights up once (green = switched
on, red = switched off).
Commissioning
You can find instruction videos on our
YouTube channel
at:
http://www.youtube.com/user/SonnenLichtManager/videos
To be able to commission the weather station as early
as 5 minutes later, it can be charged using the USB port
(Fig. 8).
Open the cover of the mounting plate and pull out the
USB cable found inside.
Connect the USB cable to a laptop or to a separately
available USB charger.
Wait approx. 5 minutes for the weather station to
charge fully.
Then press the
button for at least 5 seconds.
The status LED lights up green once. The device is
now switched on and ready for operation.
Leave the device connected via USB throughout the
commissioning procedure.
Fig. 8 USB connection of the weather station
Cs an exception: commission without ASB
If the power supply is not possible via USB, you can
also proceed as follows. However, if the product is not
commissioned swiftly, the energy stored in it up to that
point may not be sufficient to complete commissioning.
After installation, the weather station must be exposed
to daylight for at least 30 minutes.
Then press the
button for at least 5 seconds.
The status LED lights up green once. The device is
now switched on and ready for operation.
Symbols used
When the receiver is delivered, it does not "know" any
transmitters initially and first needs to learn to which
transmitters it should respond. We refer to this process as
"learning".
Power-up: To learn in a receiver, you must
de-energize a receiver or group of receivers,
either at the in-line circuit breaker or at the
associated plug-in connector, and then
switch it back on again after approx. 5
seconds. (Power-up procedure). Always
carry out a power-up procedure when you
see the symbol of the circuit breaker.
The receiver is now in learn mode for
approx. one minute. The training key on the
transmitter must be pushed within this period
or the learning mode is closed. Push the the
training key on your transmitter whenever
you see the symbol of the training key.
Wave: After the learn button on the
transmitter is activated, the connected
sun shading system carries out several
movements. In these instruction, we use the
adjacent symbol for waving. Waving once:
Press the learn button on the transmitter,
wait until the connected sun shading
system moves and then release the button
immediately.
