warema_2012123_alhb_en_v5•2022-03-01
We reserve the right to make technical modifications
2
Installation
The module is designed for distributor installation (DIN
rail-mounted housing (REG)).
When installing the device in a distributor, clip it onto a
symmetrical DIN rail (TH 35-15). For easier connection
of the device, the terminal covers can be removed (Fig.
Remove the terminal covers:
Insert a suitable screwdriver
into the notch.
Fig. 2
Detaching the terminal covers
Connection
An on-site overload current disconnecting and isolating
switch must be provided to cut off power to the entire
system.
The module is electrically connected according to the
wiring diagram on the reverse (see Fig. 5).
For loading and monitoring the device apllication
a Mini USB cable is required for the USB inter-
face.
Connection to BAline extension modules
Connect the BAline KNXMCM to an extension module
(Fig. 3). The connection of the BAline KNXMCM is locat-
ed on the right side; the device is always mounted at the
beginning of the module chain (at the far left).
Fig. 3
BAline KNXMCM module
Initial operation
Once installation is complete and the operating voltage
is supplied, the device can be placed into service. The
control software loaded at the factory must be replaced by
system-specific control software.
To create, test and load the system-specific control
software, use the BAline Studio PC software. After the
system-specific control software is loaded, the extension
modules and the connected devices can be placed in
service.
A software manual (art. no. 2014978) is available for the
BAline Studio PC software. Contact your system integrator
to request the manual.
Take suitable precautions in order to avoid
damage through electrostatic discharges!
Maintenance
There are no parts inside the device that require mainte-
nance.
Cleaning
Clean the housing with a soft, dry cloth. Do not use deter-
gents, cleaning agents, solvents, abrasive substances or
steam cleaners!
Liability
Failure to comply with the product information contained in
these instructions and any use of the device other than its
intended use and purpose may result in the manufacturer
refusing to honour warranty claims for product damage. In
this case, liability for consequential damage to persons or
property will also be excluded.
Obligations for the disposal of electrical
devices
A marking with this symbol indicates the following
obligations under the scope of legal regulations:
The owner of this electrical device must dispose of it
separately from unsorted municipal waste for further
recycling.
Used batteries and accumulators that are not enclosed
in the old device, as well as lamps/bulbs that can be
removed from the old device without breaking, must be
disposed of separately.
Distributors of electrical devices and disposal compa-
nies are obliged to take back the equipment free of
charge.
The owner must take it upon themselves to delete any
personal data contained in the electrical device prior to
disposal.
