13
Step 5: Assemble the front wall panels
Place part S86 (sheet) on the worktable. Fit part 20D (top channel), part 20E (bottom channel) and part J3 (jamb) (There are pre-drilled
holes for the next step on both parts S86 and J3 that must be aligned) and part 33R (mid wall channel) to the sheeting and fix them
with the self-tapping screws. NOTE: All screws marked with a cross should not be fixed at this stage. Make sure that the small lips on
channels 20D and 20E are always facing out. This ensures rainwater cannot build up inside your shed.
Fit part J5 (jamb), part 42 (jamb) and part 23 (bottom channel) and fix them with the self tapping screws (except those
marked with a cross). Make sure both joins (diagrams A and B) are fixed the same followed by diagrams C and D.
42
20D
20E
J3
S86
J5
33R
23
ROOF TOP EDGE
RIDGES FACING UP
Note: Holes drilled in the edge of
this sheet are not a defect. They
are there to allow the door hinge
rivets clearance through this sheet.
Note: Small lip on
channels 20D &
20E should always
be facing out.
Note: Channel 33R
should face down.
B
A
D
C
