3. If the IP Camera and 2wIP-E-C-TW are not receiving power through the wire cable, change the PoE+
Hub or plug the DC48V power adaptor into the 2wIP-E-S-TW.
Product Application Diagra
The Ethernet over UTP Cable system allows for Star topology or Daisy-Chain communication.
It supports virtually any type of CAT UTP wire, including CAT5, 5e, 6, or 7 cables. *Different wire
types can be concatenated together, as needed.
Daisy Chain
Point to Point Topology
IMPORTANT:
If you use an adapter from RJ45
to screws (Art. Nr.
5629), please note the PIN 1
-
2
-
7
-
8 are not for +48VDC
Line, the 3
-
4
-
5
-
6
are for -
48VDC Line. Be aware of the polarity, do not cross.
To avoid interference signal, we strongly recommend using the CAT STP cable for Ethernet/
PoE signal transmission when there are more than
16
pcs of the
2
wIP-E-S-TW installed at the
same switch/hub site.
If the IP Camera and 2wIP-E-C-TW do not receive power through the UTP cable, follow the instruc
-
tions below:
1.
Change the PoE+ Hub or plug a DC48V power adapter into the 2wIP-E-S-TW.
2. Plug the DC
48V power adapter into the 2wIP-E-C-TW end. Please refer to the
“Power Wattage
VS. Cable Distance”
table or visit www.wantec.de
