http://www.wansview.com
14
Figure 12
Note: When the device is connected both WIFI and wired, after it starts up, it will firstly
connect to the wired network, if it can’t connect to it, then it will change to connect the wifi.
The IP address and port is the same, either wireless or wired network.
7.1.3 ADSL Setting
User could enable the ADSL Dialup according to the below Figure 13 (The Telecom
Operators will assign the user name and password to you when you apply for ADSL
service.) Connect the device directly to the ADSL modem and it is connected to the
Internet, but don’t need to do the port forwarding.
Figure 13
7.1.4 UPnP Setting
UPNP stands for universal plug and play, if you start UPNP, once the IP camera is
connected into the LAN, it will communicate with the router in the LAN automatically. It
will request the router to open a port to forward its own port. It is no need for the users to
log in the router to set the port forwarding. Below Figure 14, tick “Using UpnP to Map
Port” and the setting are completed. You could check the UpnP succeeds or not in the
interface of System Maintenance.
Figure 14
Before using UPNP function, please make sure the router’s UPNP function has been
triggered. Because there are so many different routers, and not all of them can support
UPNP. Please test if the router work well with the equipment, if not, we would suggest
you don’t enable this function.
