![background image](http://html.mh-extra.com/html/wanhao/duplicator-9/duplicator-9_quick-start-manual_871817001.webp)
DUPLICATOR 9
GETTING
Thanks for choosing Wanhao 3D Printer products. You’re just moments away from printing your first 3D
model. It’s important that you follow these steps carefully to ensure correct setup of your 3D Printer.
STARTED
GUIDE
You can also visit
www.wanhao3dprinter.com/Video/D9 video/wanhao D9 unboxing
for step by step guide on unboxing and setup, levelling, filament installation and printing.
Package Contents:
1 x WANHAO 3D Printer
1 x Filament Spool Holder
1 x Filament Spool Stand
1 x Power Cable
1 x USB Cable
1 x 8GB SD Card
1 x Hex Screw Driver
1 x Hex Key Set
6 x Hex Bolts
2 x Plastic belts
1 x 1.75mm PLA Filament
1 x Needle for unclugging nozzle
ASSEMBLING AND MOUNTING
1
Take out all components
from the box and
place them on the flat
ground.
1-Base
2-Z axis Tower Pillar*2
3-X axis rail
4-X axis gantry
5-MK12 Extruder
Place the Base on
it’s side. Find the Z
axis pillar with sticker
No.2. Slide the No.2
pillar into the base
vertical locker. Then
tighten the bolt at
bottom of base.
2
A
D
4
5
6
Insert the leveling
card or an A4 paper
between the nozzle
and bed. Adjusting
the Z axis height,
until you can feel the
friction while moving
the card or paper.
Click the upper Z to move
extruder up and click the
lower Z to move extruder
down. Stop clicking until
you feel the leveling card
getting friction while
moving the card.
Click NEXT to initiate
auto leveling.
7
Congratulation! You have finished bed leveling. For video installation,
please scan the QR code.
Video Installation
Official Website
Wanhao Store
To move the extruder
by hand to 4 corners
separately. Adjusting
the knob at each
corner, until you feel
friction while moving
the leveling card.