14
⛳
Set up power supply via external power supply unit
⚠
WARNING
0
Danger to life due to electric current
The use of an incorrect power supply can lead to accidents with electric current
and fire
🢂
Only use power supplies according to the specification
🢂
Observe documentation
🢂
Observe safety regulations
The MQTT.box can be supplied with voltage via an external power supply
unit. Such a power supply must be potential-free and the reference ground for
the output voltage must not have a direct connection to the protective earth.
Furthermore, a safe isolation between the extra-low voltage side and the supply
network according to EN60950-1, as well as LPS property are mandatory.
•
a power supply unit that meets the specifications (see Accessories
section)
•a screwdriver
1.
Attach the green terminal adapter to the power supply unit
2.
Plug the green terminal adapter into the socket on the device
The MQTT.box starts operation.
Connect network cable
The MQTT.box is equipped with two network interfaces. These network interfa-
ces can be configured independently in the user interface. For the connection to
a network you need:
•a patch cable
1.
Connect the MQTT.box via a patch cable to the network in which you want to
integrate the device.
The MQTT.box is connected to the network.
4. Commissioning
👥
Network Administrator
This section is intended for network administrators and assumes knowledge of net-
work configuration. If you as a user do not know what to do with the steps described
here, please contact your system administrator.
Make network settings
To perform the tasks described below, you will need the following information:
•
MAC addresses of the devices to be configured
•
Network parameters of the device to be configured: IP addresses, subnet defini
-
tions, gateways, DNS and time servers.
⛳
Make network settings via the WuTility
In this section, you assign a basic network configuration to the MQTT.box using
the WuTility configuration software. If you want to configure multiple devices,
make a note of the respective MAC addresses, which you can find on the bottom
of the device. For the implementation you need:
•a current web browser
•the software WuTitliy (
🌎
www.wut.de/wutility
)
1.
Open the Wutility
2.
Select the device you want to configure by its MAC address from the list of
available devices.
3.
In the toolbar at the top, click the
IP Address
button
4.
Set the desired network parameters
5.
Click
Next
The MQTT.box adopts its setting and then restarts.
⛳
Make network settings via DHCP
If automatic configuration via DHCP is enabled in your network, your box will ob
-
tain a configuration after you have connected it to the network. To find out the IP
address of your MQTT.box, you need either
•
Access to the leases of your DHCP server, for example via the log file
or via the display of network subscribers on your router.
•the software WuTitliy (
🌎
www.wut.de/wutility
)
