W&T 18801, Руководство пользователя

Страница: 41 / 50

91
W&T
Interface modules
Subject to error and alteration
Assembly
Connecting the plastic fiber optic cable to the interface
requires no special tools:
•
Trim the fiber optic cable to the desired length using a
sharp knife. Make your cut as close to a right angle to the
longitudinal axis of the cable as possible. A simple cut is
generally sufficient, with no reworking required.
•
Separate the individual duplex conductors back from the
cut point to a distance of around 2cm.
•
Pull the locking levers on the fiber optic female connector
back towards the module along the upper side of the
coupling.
•
At the same time insert the separated end of the fiber
optic duplex line into the fiber optic coupling female.
•
Releasing the locking levers locks the fiber optics into the
coupling.
•
To release, pull the two locking levers on the top of the
coupling towards the module, and pull the fiber optic
cable out of the female.
The arrows on the top side of the coupling clearly show the
location of the emitter and receiver lines.
Please note that when connecting two fiber optic components,
the emitter of the first must always be connected to the
receiver channel of the second component. A visible red light
beam is always sent along with data, so that the sending line
can always be easily identified.