W&H teon + RID-200, Руководство по эксплуатации

Страница: 94 / 160

Programme settings
94
Change water
quantity Increasing the water level is advisable if a large amount of water
clings to items due to the structure of the wash load or if a heavy
build-up of foam might occur due to the type of soiling (e.g. blood)
and the chemical agents used. The additional amount of water re-
quired depends on the type of basket or mobile unit used, the type of
soiling and the load.
If a lightly soiled load is being reprocessed which does not hold much
water, the amount of water can be reset to the factory default amount
to save water and energy.
...
 Change volume of water
Change vol. of water
0.0
l
(0.0 - 8.5 l )
The water quantity can be increased in 0.5 l increments, or set back
to the factory default amount. The possible range is shown in the bot-
tom line. The setting “0 l” equates to the factory default setting.

Use the arrow buttons

(higher) and

(lower) to alter the water
quantity.

Press OK to save the setting.