Osmo
11
Connect the white tube from the T
fitting from the osmotic group to the
storage tank.
This is a quick-connector fitting:
insert the tube until it hits the back of
the fitting and pull slightly to check it
is correctly inserted.
To take the tube out of the fitting,
press the fitting ring with your fingers
and pull out the tube.
A
B
C
Disconnect the tube from the outlet
fitting of the carbon block cartridge
head (middle holder).
Insert the supplied red draining
tube on the fitting and tighten with a
ring nut.
Position the tube in a draining sink
or a collecting basin.
A
B
C
Open the devices tap.
Connect the transformer’s 24V
outlet wire to the osmotic group’s
power supply connector.
Insert the plug into a plug hole.
Leave the water that comes out of
the active carbon filter to drain until
the water has no more black bits.
Remove the plug form the plug-
hole.
Close the device tap
Reset the original connection on the
carbon block’s cartridge head
(disconnect the red tube, reconnect
the white tube and tighten with the
ring-nut ).
A
B
C
A
B
C
5÷15 min
B
