WANDERS STEALTH - SCHEMATICS, Руководство пользователя и инструкция по установке

Страница: 18 / 64

18
General information
It is common practice for the dealer where you purchased your gas unit to take also care of installing it and
connecting it to the mains. If this is not the case, please ensure that the installation is done by a certified
installer. Connecting gas devices by unqualified persons is prohibited, in which case we cannot give any
guarantee that your gas hearth is functioning properly.
Ready for use
After connecting your Wanders gas unit to the mains and making the necessary adjustments, the hearth is
ready for use. The pilot flame must be ignited manually.
Receiver Gas governor
Lighting the pilot flame manually
1. Open the door underneath the stove to reach the gas governor. Check if the gasvalve is open.
2. You’re now able to see the controls as shown on the images above.
3. Turn the ignition knob (A) until it stops (spark symbol / IGN), then press the knob and wait a few seconds.
4. While keeping the knob pressed, turn the knob to the left until you hear a click.
5. Look through the glass pane to see whether the pilot flame is burning. If the pilot flame is not ignited,
repeat steps 3 and 4.
6. If the pilot flame is burning, keep the ignition knob pressed for some time. When you release the knob
after 30 seconds, the pilot flame must stay alight. If it doesn’t, wait for 5 minutes before trying to light the
pilot flame again.
7. If the pilot flame stays alight, turn the knob anticlockwise till the symbol of the large flame. Now you can
close the flap and regulate the height of the flames with the remote handset.