WANDERS DANTA 1100, Инструкция по установке, обслуживанию и эксплуатации

Страница: 7 / 36

installation, servicing and user instructions manual | GB + IE
7
• Simultaneously press and hold buttons B & C (Star and Large Flame), until a short acoustic beep confirms the
start sequence has begun; release the buttons.
• Continuing signals confirm the ignition is in process.
• Once pilot ignition is confirmed, there will be gas flow and the main burner will ignite.
• Repeat process if pilot ignition fails.
2.7 To Turn the appliance OFF
Press the OFF button (Button B fig. 1.1) on the Handset. This will extinguish all Burners including Pilot.
Note: - Repeated presses of the small flame (Button D fig. 1.1) will turn the main burner OFF, but will leave the Pilot
alight.
2.8 Adjusting the Flame setting
To increase the flame height; press the large flame button (Button C fig. 1.1).
To decrease the flame height; press the small flame button (Button D fig. 1.1).
2.9 Using the "Effect" Burner
Note: The solenoid valve will not operate for one minute after Ignition.
The solenoid valve cannot be operated manually. If the battery runs down, the solenoid will remain in its
last operating position.
During normal operation the solenoid will be reset to the ON (Open) when the Gas Valve is switched OFF
via the Handset.
Upon ignition both "Main" and "Effect" burner are ON.
To switch the "Effect" burner OFF, simultaneously press the OFF and Large Flame buttons (buttons B & C fig. 1.1).
To switch the "Effect" burner ON, simultaneously press the SET and Large Flame buttons (buttons A & C fig. 1.1).
Printed instructions are located on the battery cover on the rear of the handset.
2.10 Setting °C/24 hour or °F/12 hour clock
Simultaneously press OFF and Small Flame buttons (buttons B & D fig. 1.1) until display changes from Fahrenheit/12
hour clock to Celsius/24 hour clock and vice versa.
2.11 Setting the Time
The display will flash after either:
• Installing the battery or
• Simultaneously pressing the Large Flame Button and Small Flame Button (buttons C & D fig. 1.1)
Press the Large Flame button (button C fig. 1.1) to set the hour.
Press the Small Flame button (button D fig. 1.1) to set the minutes.
Press OFF (button B fig. 1.1) to return to standard operating mode or simply wait and it will return to standard
mode after approximately 15 seconds.
2.12 Cleaning and Maintenance
This appliance should be inspected and serviced once a year by a qualified, competent and registered person.
The inspection and maintenance must at least ensure that the appliance is working correctly and safely. It is
advisable to clean the appliance of any dust and debris before regularly during the heating season and especially
if the appliance has not been used for some time. This can be done with a soft brush and a vacuum cleaner or a
damp cloth and if required a non-abrasive cleaning agent. Do not use corrosive or abrasive substances to clean
the appliance.