Wampler METAVERSE, Полное руководство пользователя

Страница: 6 / 16

Page 6 WAMPLER METAVERSE
the ‘Industry Standard’ digital delay, the TC Electronics
®
2290
®
Dynamic Digital Delay, this program is super clean for
precise, clean, and modern delay tones that are both studio and
stage worthy. Again the focus is on ease of use and this Program
is so easy to dial in with very minimal tweaking.
THE CONTROLS
There are 6 main rotary controllers on the surface of the pedal
as described below. Their physical positions will be overwritten
if you send a MIDI command that alters their parameters; if you
rotate the knob subsequent to a command it will overwrite the
previous MIDI instruction.
PROGRAM SELECTOR KNOB
This selects between the 11 different Programs. If you select a
program via MIDI the LED will change to correspond. When you
rotate it following a MIDI command it will start from where it was
last physically set.
DELAY TIME CONTROL
This selects the delay time from 25 ms (fully CCW) to 2000ms
(Fully CW) except for the TAPE program where it will start at
40ms to avoid crazy levels of self oscillation.
FEEDBACK CONTROL
This sets the level of feedback for the delay program which
controls how many repeats. For the TAPE and ETH Programs this
control is used in Alt mode (Bypass held down, Bypass LED red)
to set the head combination and Ethereal modes respectively.
TONE KNOB
Set the frequency profile of the delay effect, with most ‘bass’
and least ‘treble with the knob turned all the way CCW, and least
‘bass ‘and most ‘treble’ with the knob set all the way CW. The Alt
mode on this control sets the Modulation feedback when either
the JET or MOD programs are in use.
MOD DEPTH KNOB
This control sets the modulation depth for each program. This
can be used to alter the relative strength of the modulation
effect to the strength (Feedback) of the delay. Alt mode on this
controller will set the modulation rate for the selected program,
allowing you to further fine tune the effect.
MIX KNOB
This acts both as a master volume for the pedal and a wet / dry
mixing control. To set the dry signal and delay signal mix turn
the knob from full CCW (0%) to full CW (100%). The following
percentages indicate the blend and output levels:
0% = dry 100% + wet 0%,
75% = dry 100% + wet 100%,
100% = dry 0% + wet 100%
Alt mode on this control will set the total output level of the
selected delay setting while using or when saved/recalled:
0% = -6dB,
50% = 0dB
100% = +6dB
TRAILS SWITCH
This top mounted slide switch effects whether the pedal is run in
True Bypass or Buffered Bypass (Trails) mode - True Bypass mode
on the left), Buffered Bypass (Trails) mode to the right.